Aston Martin V8 Vantage Workshop Manual page 192

Rear Brake Hose Assembly-Renew
Repair Operation Time (ROT)
Item
Rear Brake Hose Assembly-Renew
Rear Brake Hose Assembly-Renew
Removal
1. Raise vehicle on ramp.
2. Remove road wheel/s
3. Remove bleed nipple dust caps.
4. Fit bleed bottle to RHR/LHR calliper, open bleed nipples
(x1).
5. Fit bleed bottle to RHF/LHF calliper, open bleed nipples
(x1).
6. Depress brake pedal >60 mm and secure with support.
7. Tighten RHF/LHR bleed nipple, remove bleed bottle
and fit dust cap.
8. Tighten RHR/LHR bleed nipple, remove bleed bottle.
9. Remove clips (x3) wear indicator harness to brake hose.
10. Remove brake hose from calliper (cap and plug open
orifices).
11. Remove brake union from hose.
12. Remove hose C-clip and remove hose.
Installation
1. Install hose C-clip and hose.
2. Install brake union to hose (torque).
3. Install brake pipe to calliper (torque) using alignment
tool (206-100).
4. Remove pedal support.
5. Top-up brake fluid.
6. Bleed brake calliper with assistance.
7. Remove bleed bottle.
8. Fit bleed nipple dust caps.
9. Clean off excess fluid.
10. Top-up brake fluid.
11. Install road wheel/s
12. Lower vehicle on ramp.
RH/LH Rear Brake Disc Shield Assembly-
-Renew
Repair Operation Time (ROT)
Item
Rear Brake Disc Shield Assembly-
Renew
Rear Brake Disc Shield Assembly-
Renew
Removal
1. Raise vehicle on ramp.
2. Remove RH hub and bearing assembly (see Workshop
Manual procedure 04.02.AB/04.02.AA Hub and
Bearing Assembly - Rear - RH - Renew).
October 2005
3. Remove Torx screws (x4), disc shield to vertical link,
remove shield.
Installation
Code
1. Clean disc shield and mating face on vertical link.
RH 06.04.AE
2. Install disc shield, install and torque tighten Torx screws
LH 06.04-AF
(x4).
3. Install RH hub and bearing assembly (see Workshop
Manual procedure 04.02.AB/04.02.AA Hub and
Bearing Assembly - Rear - RH - Renew).
4. Lower vehicle on ramp.
Code
RH 06.04.AG
LH 06.04.AH
Workshop Manual
Rear Disc Brakes (06.04)
Brake system (06.00)
6-2-3