Rh/Lh Engine Bracket-Renew; Engine Hydro Mount Isolator Assembly-Renew - Aston Martin V8 Vantage Workshop Manual

7. Remove nut from hydro mount to subframe (see Fig. 1). 10. Install cross brace and install and torque tighten bolts
8. Remove and discard bolts (x4), mounting bracket to
transaxle (see Fig. 2).
9. Remove mounting bracket and hydro mount.
10. Position hydro mount assembly in vice.
11. Remove nut from hydro mount to mounting bracket and
remove hydro mount.
Installation
1. Clean hydramount, mounting bracket and mating faces
on transaxle.
2. Install hydro mount to mounting bracket and tighten nut
to correct torque.
3. Remove hydro mount assembly from vice.
4. Install hydro mount assembly and install and torque
tighten new bolts (x4).
5. Install nut from hydro mount to subframe and Torque
tighten nut.
6. Remove hydraulic lifter.
7. Clean rear exhaust pipe and mating faces on centre pipe
and silencer.
8. Apply a proprietary exhaust sealant around clamp joint.
9. Install rear exhaust pipe to centre pipe (Do not torque
nut at this stage).
October 2005
Fig. 1
Fig. 2
Workshop Manual
(x4).
11. Install rear exhaust silencer (see Workshop Manual
procedure 09.00.KA Silencer and Bypass Valve
Assembly - Remove for Access & Refit).
12. Lower vehicle on ramp.

RH/LH Engine Bracket-Renew

Repair Operation Time (ROT)
Item
Engine Bracket-Renew
Engine Bracket-Renew
Removal
1. Remove LH/RH exhaust manifold (see Workshop
Manual procedure 09.00.CA/09.00.CB Manifold -
Exhaust - LH/RH - Renew
2. Remove engine mount lower fixing (nut x1).
3. Raise engine with suitable equipment.
4. Remove mount and bracket from engine (bolts x4).
5. Remove bracket from mounting (nut x1).
Installation
1. Install bracket to mounting (nut x1) (torque).
2. Install mount and bracket to engine (bolts x4) (torque).
3. Lower engine.
4. Install engine mount lower fixing (nut x1) (torque).
5. Install LH/RH exhaust manifold (see Workshop Manual
procedure 09.00.CA/09.00.CB Manifold - Exhaust - LH/
RH - Renew.
Engine Hydro mount Isolator Assembly-
Renew
Repair Operation Time (ROT)
Item
Engine Hydro mount Isolator Assembly-
Renew
Engine Hydro mount Isolator Assembly-
Renew
Removal
1. Remove RH/LH exhaust manifold (see Workshop
Manual procedure 09.00.CA/09.00.CB - Exhaust
Manifold - RH/LH - Renew
2. Remove engine mount lower fixing (nut x1).
3. Raise engine with suitable equipment.
4. Remove harness clips (x2).
5. Remove mount and bracket from engine (bolts x4).
6. Remove mounting from bracket (nut x1).
Installation
1. Install mounting to bracket (nut x1) (torque).
2. Install mount and bracket to engine (bolts x4) (torque).
3. Install harness clips (x2).
4. Lower engine.
Subframes (02.03)
Frame and Mounting (02.00)
Code
LH 02.03.BE
RH 02.03.BF
Code
RH 02.03.BG
LH 02.03.BH
2-1-11