Rear Suspensions Sensor Assembly-Renew - Aston Martin V8 Vantage Workshop Manual

13. Install ABS sensor multiplug.
14. Install toe rod to vertical link, install bolt/nut. Do not
torque tighten at this stage.
15. Install road wheel/s
16. Pump brake pedal.
17. Lower vehicle on ramp.
18. With assistance, torque tighten rear hub nut.
19. Correctly torque tighten all suspension nuts/bolts.
20. 4 wheel alignment - check/adjust(see Workshop Manual
procedure 04.00.AD 4 Wheel Alignment - Check and
Adjust)
Rear Suspension Sensor Assembly-
Renew
Repair Operation Time (ROT)
Item
TBA
Removal
1. Raise vehicle on ramp.
2. Remove nut/bolt ride height sensor link to upper
suspension arm.
3. Remove bolts (x2), ride height sensor to subframe.
4. Disconnect sensor multiplug and remove sensor.
Installation
1. Position ride height sensor to subframe, install and
torque tighten bolts (x2).
2. Connect sensor multiplug.
3. Align sensor link to upper suspension arm, install and
torque tighten bolt/nut.
4. Lower vehicle on ramp.
October 2005
Code
Workshop Manual
Rear Suspension (04.02)
Suspension (04.00)
4-3-5