Viewing And Deleting Measurement Results; Basic Measurements In 2D - FujiFilm SonoSite X-Porte User Manual

Viewing and deleting measurement results

The current measurement result appears on the left side of the touch panel under Measure. To assign it to
a calculation, see "Assigning measurements to calculations"
If you perform multiple measurements, tapping an entry under Measure highlights the corresponding
calipers on the image.
To delete a measurement

Tap the measurement under Measure, and then tap Delete.

Basic measurements in 2D

Note
To measure the distance between two points
1 On a frozen image, tap Distance.
A caliper appears.
If this control is hidden, tapping More Controls displays it.
2 Drag the active caliper to the first point.
3 Drag the other caliper to the second point.
4 As needed, tap and drag each caliper until it is precisely positioned.
To measure circumference or area using an ellipse
1 On a frozen image, tap Ellipse.
If this control is hidden, tapping More Controls displays it.
An ellipse with three calipers appears.
2 Position and resize the ellipse:
To position, drag the calipers.
To resize, drag the calipers, the handle, or both.
To measure circumference or area by tracing
1 On a frozen image, tap Trace.
If this control is hidden, tapping More Controls displays it.
A caliper appears.
5-2
You can measure across images in Dual only with a linear transducer, and only
when the images are at the same depth and magnification.
on page 5-8.
Measurements and calculations