Measuring During Review - FujiFilm SonoSite X-Porte User Manual

5 Enter up to 20 headings (for example, procedures).
6 Enter check box items underneath each heading.
7 Tap Save Changes to save changes or Done to exit.

Measuring during review

You can measure images during an exam or during review, after an exam has ended. You must save to
obtain an image with measurements added in review. Enable the system to display the Save Image or Save
Image & Calcs control. See
Note Doppler Angle Correct cannot be performed in review.
To measure in review
1 In Review, tap the image or video clip that you want to measure. You can only make measurements in
full screen:
To view the previous or next image or video clip, tap Prev or Next.
(Video clips only) Use the scroll arrows, or tap the pause button, and then drag the slider to the frame
you want to measure.
2 Select a measurement from the Calcs or Acute Care menus, or select a basic measurement.
Note You can only take calculations that are available for the exam type used when
capturing the original image.
3 To make a measurement:
See
"Measuring"
See
"Exam-based calculations"
See
"Acute Care calculations"
4 Tap Save Image or Save Image & Calcs to save an image with your measurements. The original image
will remain.
Worksheets can be edited until the report has been generated.
Note Measurements made in review will always generate a separate report. Review
measurements are not added to any measurements made during an exam.
Measurements and calculations
"To configure custom controls"
on page 5-1, to make a basic measurement.
on page 5-13 to make a measurement from the Calcs menu.
on page 5-45, to make an acute care measurement.
on page 3-33.
5-57