General Interaction; Clinical Monitor - FujiFilm SonoSite X-Porte User Manual

Cautions
To connect a USB memory stick for importing or exporting

Insert the USB memory stick into a USB port (see
The USB memory stick is ready when the USB icon
To view information about the device, see
To disconnect a USB memory stick
Disconnecting the USB memory stick while the system is exporting to it may cause the exported files to be
corrupted or incomplete.
1 If exporting, wait at least five seconds after the USB animation icon
2 Remove the USB memory stick from the port.

General interaction

Clinical monitor

WARNINGS
2-6
To avoid damaging the USB memory stick and losing patient data from it, observe
the following:

Do not remove the USB memory stick or turn off the ultrasound system
while the system is exporting.

Do not bump or otherwise apply pressure to the USB memory stick while it is
in a USB port on the ultrasound system. The connector could break.
If the USB icon
monitor, the USB memory stick may be defective or software-encrypted.
Replace the USB memory stick.
"USB settings"
FUJIFILM SonoSite does not recommend using a monitor other than the clinical
monitor provided by FUJIFILM SonoSite. Only the images presented on the
clinical monitor are validated for the intended use of the device.
Do not use a monitor connected through the external VGA or digital video out
for medical diagnosis.
does not appear in the system status area on the clinical
"About the system"
appears onscreen.
on page 3-36.
on page 2-1).
stops.
Getting started