FujiFilm SonoSite X-Porte User Manual page 122

3 Tap Done.
To capture and save a video clip
1 Make sure that video clips settings are set as desired. See
2 Tap Save Video Clip.
Note
If Clip Method is set to Retrospective, the system beeps if Beep Alert is on (see
page 3-6), and then captures presaved frames for the number of seconds you specify in the Time list.
If Clip Method is set to Prospective, the system beeps if Beep Alert is on (see
page 3-6), and then captures frames for the number of seconds you specify in the Time list, and then
beeps again. Tap Stop Video Clip to end capture before the number of seconds specified in the Time list.
If Preview Video Clip is selected in Video Clip Settings, the video clip automatically begins playing on
the clinical monitor.
3 (Optional, Preview Video Clip only) Trim the video clip:
a Tap the scissors icon.
b Drag the trim sliders to remove frames from the left or right sides of the video clip.
c Tap Save.
Note
Managing internal storage space
The save available icon in the system status area (see
space available in internal storage.
To receive alerts when storage is near capacity, see
If you try to save an image or video clip when space is low, the system alerts you that internal storage is
low and prompts you to delete archived or storage committed patient exams.
If memory is full, the system displays the Memory Full icon
4-46
You can also configure the footswitch to save a video clip (see
settings" on page 3-32).
Tapping Done discards the video clip.
"To set video clips controls"
Figure 2-4 on page 2-7) shows the percentage of
"To receive storage alerts"
.
on page 4-45.
"User profile
"Audio settings" on
"Audio settings" on
on page 3-12.
Imaging