Intended Uses - FujiFilm SonoSite X-Porte User Manual

Figure 2-8 A Visual Guide video
Note
To play a Visual Guide video
1 Display the Visual Guide screen by doing one of the following:
Tap LEARN on the startup screen.
In the upper right corner of the touch panel, tap LEARN, or tap MORE and then tap LEARN,
depending on your setup.
To specify the location of this command, see
2 At the top of the Visual Guide screen, tap a category (for example, Basics).
The current selection is highlighted.
3 Tap a video selection in one of the cards that appear.
4 Tap the left and right controls to show additional cards.
The video player starts. Tap the play button to play your selection.
5 Do any of the following:
Pause or restart the video using the controls at the bottom of the player.
Tap the volume control to mute the audio. Tap again to unmute.
Drag the volume slider to adjust the volume.
Tap Hide to hide the player. (You can tap LEARN to show the player again.)
Tap another video in the list to play it.
Tap LEARN to return to the Visual Guide screen.

Intended uses

The system is used with a transducer attached and is powered either by battery or by AC electrical power.
The clinician is positioned beside the patient and places the transducer onto the patient's body where
needed to obtain the desired ultrasound image.
The system transmits ultrasound energy into the patient's body to obtain ultrasound images as listed below.
For the intended transducer and imaging modes for each exam type, see
exam type" on page 2-14.
2-24
Some Visual Guide videos may display incorrect representations of the X-Porte
user interface due to using different versions of the software.
"Presets settings" on page 3-28.
"Selecting a transducer and
Getting started