Dell PowerConnect J-EX4200-24T Software Manual page 1207

Table 150: VLAN Configuration Details (continued)
Field
Ports
IP address tab
IPv4 address
IPv6 address
Voip tab
Ports
Related
Documentation
Function
Specifies the ports (interfaces) to be
associated with this VLAN for data
traffic. You can also remove the port
association.
Specifies IPv4 address options for the
VLAN.
Specifies IPv6 address options for the
VLAN.
Specifies the ports to be associated with
this VLAN for voice traffic. You can also
remove the port association.
NOTE: VoIP is not supported on
J-EX8200 switches.
Configuring VLANs for J-EX Series Switches (CLI Procedure) on page 1136
Example: Setting Up Basic Bridging and a VLAN for a J-EX Series Switch on page 1063
Understanding Bridging and VLANs on J-EX Series Switches on page 1041
Configuring Routed VLAN Interfaces (CLI Procedure) on page 1137
Chapter 59: Configuring Bridging and VLANs
Your Action
Click one:
—Select the ports from the available list.
Add
—Select the port that you do not want
Remove
associated with the VLAN.
Select s to enable the IPv4 address options.
IPv4 addres
To configure IPv4:
1. Enter the IP address.
2. Enter the subnet mask—for example,
You can also specify the address prefix.
3. To apply an input firewall filter to an interface, select
the firewall filter from the list.
4. To apply an output firewall filter to an interface, select
the firewall filter from the list.
5. Click the ARP/MAC Details
address and MAC address in the window that is
displayed.
Select IPv6 addres s to enable the IPv6 address options.
To configure IPv6:
1. Enter the IP address—for example:
2001:ab8:85a3::8a2e:370:7334
2. Specify the subnet mask.
Click one:
—Select the ports from the available list.
Add
—Select the port that you do not want
Remove
associated with the VLAN.
255.255.255.0 .
button. Enter the static IP
.
1135