Dell PowerConnect J-EX4200-24T Software Manual page 1175

Table 146: Components of the Redundant Trunk Link Topology
Property
Switch hardware
Trunk port interfaces
Redundant trunk group
Configuration
CLI Quick
Configuration
Figure 30 on page 1103 displays an example topology containing three switches. Switch 1
and Switch 2 make up the distribution layer, and Switch 3 makes up the access layer.
Switch 3 is connected to the distribution layer through trunk ports
and ge-0/0/10.0 (Link 2).
Table 146 on page 1103 lists the components used in this redundant trunk group.
Figure 30: Topology for Configuring the Redundant Trunk Links
This configuration example creates a redundant trunk group called
The trunk ports
ge-0/0/9.0
will be configured administratively as the primary link. The trunk port
ge-0/0/9.0
will be the secondary link.
ge-0/0/10.0
To quickly configure the redundant trunk group
commands and paste them into the switch terminal window:
Chapter 58: Examples: Bridging and VLAN Configuration
Settings
Switch 1–1 J-EX4200 distribution switch
Switch 2–1 J-EX4200 distribution switch
Switch 3–1 J-EX4200 access switch
On Switch 3 (access switch):
group1
and are the two links in
ge-0/0/10.0
group1
(Link 1)
ge-0/0/9.0
and
ge-0/0/9.0 ge-0/0/10.0
on Switch 3.
group1
. The trunk port
group1
on Switch 3, copy the following
1103