Verifying Ip Directed Broadcast Status - Dell PowerConnect J-EX4200-24T Software Manual

Meaning
Related
Documentation

Verifying IP Directed Broadcast Status

Purpose
Action
Related
Documentation
Input packets:
Output packets:
IPv6 transit statistics:
Input bytes :
Output bytes :
Input packets:
Output packets:
Protocol inet, Generation: 144, Route table: 0
Flags: uRPF
Addresses, Flags: Is-Preferred Is-Primary
The show interfaces ge-1/0/10 extensive
command) displays in-depth information about the interface. The
detail
field near the bottom of the display reports the unicast RPF status. If unicast RPF has
not been enabled, the
uRPF
On J-EX4200 switches, unicast RPF is implicitly enabled on all switch interfaces, including
aggregated Ethernet interfaces (also referred to as link aggregation groups or LAGs) and
routed VLAN interfaces (RVIs) when you enable unicast RPF on a single interface.
However, the unicast RPF status is shown as enabled only on interfaces for which you
have explicitly configured unicast RPF. Thus, the
for which you have not explicitly configured unicast RPF even though unicast RPF is
implicitly enabled on all interfaces on J-EX4200 switches.
show interfaces xe- on page 1019
Example: Configuring Unicast RPF on a J-EX Series Switch on page 900
Configuring Unicast RPF (CLI Procedure) on page 927
Disabling Unicast RPF (CLI Procedure) on page 928
Troubleshooting Unicast RPF on page 941
Verify that IP directed broadcast is enabled and is working on the subnet.
Use the
show vlans extensive
and working on the subnet as shown in the following example.
Configuring IP Directed Broadcast (CLI Procedure) on page 929
Example: Configuring IP Directed Broadcast on a J-EX Series Switch on page 904
0
0
0
0
0
0
command (and the
flag is not displayed.
uRPF
command to verify that IP directed broadcast is enabled
Chapter 53: Verifying Interfaces
0 pps
0 pps
show interfaces ge-1/0/10
output
Flags:
flag is not displayed on interfaces
937