Dell PowerConnect J-EX4200-24T Software Manual page 986

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 123: Port Edit Options (continued)
Field Function
IPv4 Address Specifies an IPv4 address for the interface.
NOTE: If the IP address is cleared, the interface
still belongs to the
IPv6 Address Specifies an IPv6 address for the interface.
NOTE: If the IP address is cleared, the interface
still belongs to the
Table 124: Recommended CoS Settings for Port Roles
CoS Parameter
Forwarding Classes
Schedulers
Scheduler maps
ieee-802.1 classifier
dscp classifier
Related
Documentation
914
inet family.
family.
inet
Recommended Settings
There are four forwarding classes:
—Queue number is set to 7.
voice
expedited-forwarding —Queue number is set to 5.
—Queue number is set to 1.
assured-forwarding
—Queue number is set to 0.
best-effort
The schedulers and their settings are:
Strict-priority—Transmission rate is set to 10 percent and buffer size to 5 percent.
Expedited-scheduler—Transmission rate is set to 30 percent, buffer size to 30 percent, and
priority to .
low
Assured-scheduler—Transmission rate is set to 25 percent, buffer size to 25 percent, and
priority to low .
Best-effort scheduler—Transmission rate is set to 35 percent, buffer size to 40 percent, and
priority to low .
When a desktop and phone, routed uplink, or layer 2 uplink role is applied on an interface, the
forwarding classes and schedulers are mapped using the scheduler map.
Imports the default
ieee-802.1
code point 101 for the voice
Imports the default classifier configuration and sets the loss priority to
dscp
point 101110 for the forwarding class.
voice
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 919
Monitoring Interface Status and Traffic on page 931
Your Action
1. To specify an IPv4 address, select the check box
.
IPv4 address
2. Type an IP address—for example:
3. Enter the subnet mask or address prefix. For
example, 24 bits represents
4. Click OK .
1. To specify an IPv6 address, select the check box
IPv6 address .
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
4. Click .
OK
classifier configuration and sets the loss priority to
forwarding class.
10.10.10.10 .
.
255.255.255.0
.
for the
low
for the code
low