Example: Setting Up Q-In-Q Tunneling On J-Ex Series Switches - Dell PowerConnect J-EX4200-24T Software Manual

Meaning
Related
Documentation

Example: Setting Up Q-in-Q Tunneling on J-EX Series Switches

Requirements
Overview and Topology
Table 147: Components of the Topology for Setting Up Q-in-Q Tunneling
Interface
ge-0/0/11.0
ge-0/0/12.0
ge-0/0/13.0
ge-0/0/14.0
The show redundant-trunk-group
on the switch and which trunk links are members of the group. For this configuration
example, the output shows that the redundant trunk group
switch. The beside trunk port
(P)
link. The beside the
(A) ge-0/0/10.0
Understanding Redundant Trunk Links on J-EX Series Switches on page 1049
Service providers can use Q-in-Q tunneling to transparently pass Layer 2 VLAN traffic
from a customer site, through the service provider network, to another customer site
without removing or changing the customer VLAN tags or class-of-service (CoS) settings.
You can configure Q-in-Q tunneling on J-EX Series switches.
This example describes how to set up Q-in-Q:
Requirements on page 1105
Overview and Topology on page 1105
Configuration on page 1106
Verification on page 1107
This example requires one J-EX Series switch.
Before you begin setting up Q-in-Q tunneling, make sure you have created and configured
the necessary customer VLANs. See "Configuring VLANs for J-EX Series Switches (CLI
Procedure)" on page 1136 or "Configuring VLANs for J-EX Series Switches (J-Web
Procedure)" on page 1133.
In this service provider network, there are multiple customer VLANs mapped to one
service VLAN.
Table 147 on page 1105 lists the settings for the example topology.
Description
Tagged S-VLAN trunk port
Untagged customer-facing access port
Untagged customer-facing access port
Tagged S-VLAN trunk port
Chapter 58: Examples: Bridging and VLAN Configuration
command lists all redundant trunk groups configured
indicates that it is configured as the primary
ge-0/0/9.0
trunk port indicates that it is the active link.
is configured on the
group1
1105