Dell PowerConnect J-EX4200-24T Software Manual page 1096

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 139: show interfaces xe- Output Fields (continued)
Field Name Field Description
Filter statistics Receive
subsystem.
Autonegotiation Information about link autonegotiation:
information
Negotiation status:
Incomplete
No autonegotiation
configured or does not perform autonegotiation.
Complete
autonegotiation and the autonegotiation process is successful.
Link partner status
performs autonegotiation and the autonegotiation process is successful.
Link partner:
Link mode
either
Flow control
device. For Fast Ethernet interfaces, the type is
interfaces, types are
and transmit),
Symmetric/Asymmetric
transmit or
Remote fault
indicates a receive link error.
Negotiation error
link partner is going offline.
Local resolution
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
PAUSE
PAUSE
Remote fault
receive),
detected on receive).
Packet Forwarding Information about the configuration of the Packet Forwarding Engine:
Engine
Destination slot
configuration
NOTE: For a J-EX4200 standalone switch, the FPC slot number refers to the
switch itself and is always
refers to the member ID. In a J-EX8200 switch, the FPC slot number refers to
the line card slot number.
1024
and Transmit statistics reported by the PIC's MAC address filter
—Ethernet interface has the speed or link mode configured.
—Remote Ethernet interface has the speed or link mode
—Ethernet interface is connected to a device that performs
— OK when Ethernet interface is connected to a device that
—Depending on the capability of the attached Ethernet device,
or
Full-duplex Half-duplex
—Types of flow control supported by the remote Ethernet
Symmetric
Asymmetric (link partner supports
(link partner supports
only on receive).
PAUSE
—Remote fault information from the link partner—
OK
indicates a negotiation error.
—Information from the link partner:
—Types of flow control supported by the remote Ethernet
on receive and transmit),
PAUSE
on transmit), and
Symmetric/Asymmetric
on both receive and transmit or
—Remote fault information.
(local interface is offline), and
Offline
—FPC slot number.
0 . In a Virtual Chassis configuration, FPC slot number
.
None . For Gigabit Ethernet
(link partner supports
PAUSE
PAUSE on transmit), and
on both receive and
PAUSE
indicates that the link partner is receiving.
indicates that the
Offline
(link partner
Symmetric
(link partner supports
Asymmetric
(link partner supports
only on receive).
PAUSE
(no error detected on
Link OK
(link error
Link Failure
Level of Output
extensive
extensive
on receive
Failure
extensive