Dell PowerConnect J-EX4200-24T Software Manual page 984

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 123: Port Edit Options (continued)
Field Function
Wireless Access Applies the wireless access point role.
Point
The interface family is set to
port mode is set to
with the
Routed Uplink Applies the routed uplink role.
The interface family is set to
recommended CoS parameters are set for
schedulers and classifiers. See Table 124 on
page 914 for more CoS information.
Layer 2 Uplink Applies the Layer 2 uplink role.
The interface family is set to
port mode is set to
the
point-to-point
to
dhcp-trusted
None Specifies that no port role is configured for the
selected interface.
NOTE: See "Port Role Configuration with the J-Web InterfaceCLI Reference" on page 915 for details on the CLI commands that
are associated with each port role.
NOTE: For a J-EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
912
ethernet-switching
, and RSTP is enabled
access
and options.
edge point-to-point
, and
inet
ethernet-switching
, RSTP is enabled with
trunk
option, and port security is set
.
Your Action
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface. Type the
2. Click to view CLI commands for this role.
Details
3. Click .
OK
To specify an IPv4 address:
1. Select the check box
2. Type an IP address—for example:
3. Enter the subnet mask or address prefix. For
example, 24 bits represents
4. Click .
OK
To specify an IPv6 address:
1. Select the check box
2. Type an IP address—for example:
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
4. Click .
OK
1. For this port role you can select a VLAN member
and associate a native VLAN with the interface.
,
2. Click Details to view CLI commands for this role.
3. Click .
OK
for a new VLAN.
VLAN ID
.
IPv4 address
.
10.10.10.10
.
255.255.255.0
IPv6 address .
.