Table of Contents
Advertisement
Related
Documentation
Configuring MAC Notification (CLI Procedure)
To enable L2PT for all supported protocols:
[edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2-protocol-tunneling all
(Optional) Configure the drop threshold:
3.
NOTE: If you also configure the shutdown threshold, ensure that you
configure the drop threshold value to be less than or equal to the shutdown
threshold value. If the drop threshold value is greater than the shutdown
threshold value and you to try to commit the configuration changes, the
commit will fail.
[edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stp
drop-threshold 50
(Optional) Configure the shutdown threshold:
4.
NOTE: If you also configure the drop threshold, ensure that you configure
the shutdown threshold value to be greater than or equal to the drop
threshold value. If the shutdown threshold value is less than the drop
threshold value and you to try to commit the configuration changes, the
commit will fail.
[edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stp
shutdown-threshold 100
NOTE: Once an interface is disabled, you must explicitly reenable it using
the
clear ethernet-switching layer2-protocol-tunneling error
Otherwise, the interface remains disabled.
Example: Configuring Layer 2 Protocol Tunneling on J-EX Series Switches on page 1126
Understanding Layer 2 Protocol Tunneling on J-EX Series Switches on page 1056
When a switch learns or unlearns a MAC address, SNMP notifications can be sent to the
network management system at regular intervals to record the addition or removal of
the MAC address. This process is known as MAC notification.
The MAC notification interval defines how often Simple Network Management Protocol
(SNMP) notifications logging the addition or removal of MAC addresses on the switch
are sent to the network management system.
Chapter 59: Configuring Bridging and VLANs
command.
1151
Advertisement
Chapters
Table of Contents
Troubleshooting
