Dell PowerConnect J-EX4200-24T Software Manual page 1092

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Table 139: show interfaces xe- Output Fields
Field Name Field Description
Physical Interface
Physical interface Name of the physical interface.
Enabled State of the interface.
Index number of the physical interface, which reflects its initialization sequence.
Interface index
SNMP index number for the physical interface.
SNMP ifIndex
Unique number for use by Dell Support only (see "Requesting Technical Support"
Generation
on page lxxi).
Encapsulation being used on the physical interface.
Link-level type
Maximum transmission unit size on the physical interface.
MTU
Speed Speed at which the interface is running.
Duplex Duplicity of the interface.
blah blah
BPDU Error
Loopback status:
Loopback
or
Local
Source filtering Source filtering status:
Flow control Flow control status:
Information about the physical device.
Device flags
Information about the interface.
Interface flags
Information about the link.
Link flags
Configured wavelength, in nanometers (nm).
Wavelength
Frequency associated with the configured wavelength, in terahertz (THz).
Frequency
CoS queues Number of CoS queues configured.
Schedulers Number of CoS schedulers configured.
Hold-times Current interface hold-time up and hold-time down, in milliseconds.
Configured MAC address.
Current address
1020
or
Enabled Disabled
.
Remote
Enabled or Disabled
Enabled or Disabled
. If loopback is enabled, type of loopback:
.
.
Level of Output
All levels
All levels
none
detail extensive
none
detail extensive
detail extensive
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
All levels
detail extensive none
extensive
detail extensive
none
detail extensive