Dell PowerConnect J-EX4200-24T Software Manual page 888

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS
Solution
Related
Documentation
816
If a switch had been previously connected as a member of a Virtual Chassis configuration,
it retains the member ID that it was assigned as a member of that configuration even
after it is disconnected and operating as a standalone switch. The interfaces that were
configured while the switch was a member of the Virtual Chassis configuration retain
the old member ID as the first digit of the interface name.
For example, if the switch was previously member
and so on.
To change the switch's member ID, so that its member ID is
interfaces accordingly, enter the following operational-mode commands:
To change the member ID to 0:
1.
user@switch> request virtual-chassis renumber member-id 1 new-member-id 0
To rename the interfaces to match the new member ID:
2.
user@switch# replace pattern ge-1/ with ge-0/
Monitoring Virtual Chassis Configuration Status and Statistics on page 809
Configuring a Virtual Chassis (CLI Procedure) on page 781
Configuring a Virtual Chassis (J-Web Procedure) on page 784
For more information about the
http://www.juniper.net/techpubs/software/junos/
, its interfaces are named
1
0
replace command, see Junos OS CLI User Guide at
.
ge-1/0/0
, and to rename the switch's