When The Communication Module/Board Is Used - Mitsubishi Electric A960GOT User Manual

2 SYSTEM CONFIGURATION

2.3.4 When the communication module/board is used

Connection format
Bus connection
RS-232C
communication
CPU direct
connection
RS-422
communication
RS-232C
communication
Computer link
connection
RS-422
communication
CC-Link connection
Ethernet connection
2 - 7
POINT
• About the hardware version
Confirm the hardware version with the products rating plate.
(Products that the EMC directive applies to are marked with the CE mark logo.)
GRAPHIC OPERATION TERMINAL
A960GOT-EBA-EU
MODEL
IN 100-240VAC 50/60Hz POWER MAX115VA
DATE
LISTED 80M1
IND. CONT. EQ.
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
• About the connection destination device
If connecting to a PLC not from this company (MELSEC-Q series, MELSEC-QnA
series, MELSEC-A series), refer to the manual of the connected device (PLC,
microcomputer) for information about the applicability of the EMC directive.
If the EMC directive is applicable, use the communication module/board shown below.
(Available May, 2001).
If a communication module/board other than those shown below is used, it will not
apply to the EMC directive.
A9GT-BUSS (Hardware version C or later)
A9GT-BUS2S (Hardware version C or later)
A9GT-RS2 (Hardware version B or later)
A9GT-RS4 (Hardware version B or later)
A9GT-RS2 (Hardware version B or later)
A9GT-RS4 (Hardware version B or later)
A8GT-J61BT13 (Hardware version E or later)
A9GT-J71E71-T (Hardware version C or later)
0105LR
BD992C082H01
CE mark logo
Communication module/board
MELSEC-GOT
L R
Hardware version
2 - 7