Configuring Route Redistribution To Rip - Avaya 8800 Configuration Manual

RIP configuration using Enterprise Device Manager
OutPolicy
Cost
HolddownTime
TimeoutInterval

Configuring route redistribution to RIP

Configure a redistribute entry to announce routes of a certain source protocol type into the RIP
domain, for example, static, RIP, or direct. Use a route policy to control the redistribution of
routes.
Prerequisites
• RIP is globally enabled.
• A route policy is configured.
• To configure RIP on a specific VRF instance, first change the VRF instance as required.
The VRF must have an RP Trigger of RIP. Not all parameters are configurable on non0
VRFs.
Important:
Changing the RIP Redistribute context is a process-oriented operation that can affect system
performance and network reachability while you perform the procedures. Therefore, Avaya
recommends that if you want to change default preferences for a RIP Redistribute context,
you must do so before you enable the protocols.
70 Configuration — OSPF and RIP
Variable Value
the route when it is added to the routing
table.
Determines if RIP advertises a route from the
routing table on this interface. This policy
also specifies the parameters of the
advertisement.
Indicates the RIP cost for this interface. The
range is 1 to 15. The default is 1.
Configures the length of time that RIP
continues to advertise a network after
determining it is unreachable. The range is 0
to 360 seconds. The default is 120 seconds
Configures the RIP timeout interval in
seconds. The range is 15 to 259 200
seconds. The default is 180 seconds.
June 2011