Output Processing; Output Trim Block - Extron electronics XMP 240 C AT User Manual

Output Processing

The output processing chain in DSP Configurator is represented by a string of blocks (see
figure 83). Each block contains a specific processor or type of processor. Each output
contains the following processor chain:
1.
2.
3.
4.
5.
Figure 83.

Output Trim Block

Double-click the output
Figure 84.
The
the selected output.
Figure 85.
1
2
3
4
5
Output Trim Block
Output Delay Block
Output Filter Block
Output Dynamics Block
Output Attenuation Block
Output Processing Chain
block to open the
Trim
Output Trim Block
Post-mixer Trim dialog box provides pre-processing gain and attenuation control for
Output Name
1
Post-mixer Trim Fader
2
Post-mixer Trim Text Box
3
OK Button
4
Cancel Button
5
Post-mixer Trim Dialog Box
Output Name — This name changes to match the default or user defined output name.
Post-mixer Trim Fader — Click and drag the trim fader to provide up to 12 dB of gain
or 12 dB of attenuation in 0.1 dB steps. Click the trim fader and use the
to adjust the fader up or down in 0.1 dB steps.
<Down Arrow>
Post-mixer Trim Text Box — Allows the user to enter a gain or attenuation value in
0.1 dB steps.
OK Button — Confirms changes made to the contained parameters and closes the
dialog box.
Post-mixer Trim
Cancel Button — Reverts any changes made to the contained parameters back to
their states when the current instance of the
and closes the dialog box.
dialog box.
Post-mixer Trim
dialog box was opened
Post-mixer Trim
XMP 240 C AT • DSP Configurator Software
or
<Up Arrow>
53