Table of Contents
Advertisement
Front Panel Features
and Operation
This section contains a description of the IPL T PC1 and IPL T PC1i front panel features and
instructions for setting up the PC1 using the front panel. The following topics are discussed:
•
•
•
Front Panel Features
H
H
Figure 8.
A
B
C
D
E
F
G
Front Panel Features
Setting Up the System Using the Front Panel
Resetting
A
A
B
B
IPL T PC1
POWER
R
TX
RX
G
G
F
F
IPL T PC1 and IPL T PC1i Front Panel
Power button — Press this button to switch power on and off to the output receptacle
on the rear panel.
Tx and Rx LEDs — The Tx (transmit) LED lights when RS-232 data is being
transmitted. The Rx LED lights when RS-232 data is being received.
Input LED — This green LED lights when the Input contact closure port is activated
(shorted).
LAN status LEDs — These three LEDs show the status of the Ethernet connection as
follows:
•
100 — When lit, indicates a 100 Mbs connection speed. Otherwise, the connection
speed is 10 Mbs.
Link — Lights steadily while the interface has an active network connection.
•
•
Act (Activity) — Blinks while data is being sent or received.
IR LED — This green LED lights when IR data is being transmitted.
Receptacle power LED — This red LED lights while power is being supplied to the
rear panel receptacle and, therefore, to the attached output device.
Reset button (recessed) — Use the tip of a small Phillips screwdriver or an Extron
Tweeker (provided) to press this recessed button to reset the unit in one of five reset
modes (see
Resetting
on page 12 for details on reset modes and on using this
Reset button).
C
C
100
D
D
INPUT
LINK
IR
ACT
E
E
IPL T PC1 • Front Panel Features and Operation
10
Advertisement
Table of Contents
