Protocols Group; Redundancy Group; Operation And Maintenance Group; Statistics Group - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
SNMP Interface
19.6.4

Protocols Group

The protocols groups allows user to control networking protocols such as IGMP.
19.6.4.1 IGMP Subgroup
This subgroups controls the IGMP, Internet Group Management Protocol, which is the
standard for IP multicasting in the Internet.
19.6.5

Redundancy Group

This group controls a redundant pair of modems.
19.6.6

Operation and Maintenance Group

This groups contains several miscellaneous operations for the IP Controller card,
including saving the IP Controller's configuration, restoring factory defaults, and
resetting the IP Controller. This groups also allows the user to define which image to
boot from and into which image to save a new bulk file.
19.6.7

Statistics Group

This group collects various statistics on the IP Controller's Ethernet interface, satellite
interface, IP routing, QoS, and Compression.
19.6.7.1 Ethernet Statistics
The cdmipEthernetStatistics section collects statistics reported on the Ethernet network
card.
19.6.7.2 IP Routing Statistics
The cdmipIpRoutingStatistics reports statistics collected by the IP router mechanism.
19.6.7.3 QoS Statistics
This subgroup contains the Quality of Service (QoS) statistics elements. This is
implemented as a table with maximum number of configured QoS rules, as the rows.
Note: This subgroup will only be accessible in the MIB tree if the QoS FAST feature
has been purchased and activated. Otherwise, both gets GETs and sets SETs
on these OIDs will return errors.
19–15
Revision 3
MN/CDM570L.IOM