Monitor Group - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
SNMP Interface
19.7.2.8 BUC Parameters
This section allows the user to configure BUC parameter if a BUC unit is attached to the
modem via the FSK link.
19.7.2.9 LNB Parameters
The section allows a user to configure LNB parameters when a LNB is attached to the
modem via the FSK link.
19.7.3

Monitor Group

This groups reports the modem's status, including alarms, demodulator parameters, event
log entries, statistics entries, AUPC parameters, and BUC/LNB parameters.
19.7.3.1 Alarms Parameters
The cdm570LAlarms section reports any alarms that have been raised in the modem,
including the modulator, demodulator, and BUC/LNB unit.
19.7.3.2 Rx Parameters
The cdm570LRxParams section reports the demodulator's bit error rate, buffer fill state,
frequency offset, receive signal level, and Eb/No value.
19.7.3.3 Event Log Parameters
The event log is a table that informs the user of any faults that have occurred in the
modem. Event entries may also include informational items, such as power on/off.
19.7.3.4 Statistics Parameters
The statistics log is a table that gathers data concerning receive Eb/No and transmit
power level increases over time. The user can decide to collect these statistics on
intervals ranging from 10 minutes to 90 minutes.
19.7.3.5 AUPC Parameters
The cdm570LAUPCParams section reports the Eb/No value of the far-end demodulator
and any transmit power level increases that have occurred because of AUPC.
19–18
Revision 3
MN/CDM570L.IOM