Comtech EF Data CDM-570 Installation And Operation Manual page 224

CDM-570/570L Satellite Modem with Optional IP Module
IP Module CLI and Telnet Operation
IMPORTANT
The CLI and Telnet Access Levels are defined as follows:
User Interface
CLI
(direct to console port)
Telnet
Default Name/Passwords are:
•
Admin
•
Read/Write
•
Read Only
Any changes made to the IP MODULE will be lost if the IP MODULE is reset
or loses power unless the changes are saved to permanent storage. This
applies to all of the IP MODULE parameters. The IP MODULE parameters
can be saved by selecting "S", available on any CLI/Telnet Menu page.
All base modem parameters configured via the IP MODULE (i.e., TX
Frequency, data rate, etc.) and the Ethernet Port Address/Mask will be
automatically stored in the CDM-570/570L base modem non-volatile RAM
and will be retained if there is a power loss.
User Login Access Level
Admin User
Full Access – no Login
Full Access
all Menus
comtech/comtech
opcenter/1234
monitor/1234
Read/Write User
No Access to Admin Menu
Full Access all other Menus
17–2
Revision 3
MN/CDM570L.IOM
Read Only User
No Access