Comtech EF Data CDM-570 Installation And Operation Manual page 81

CDM-570/570L Satellite Modem with Optional IP Module
Front Panel Operation
Distant-end Base Address
(◄ ►,▲ ▼,ENTER)
0240
Edit the address of the distant-end modem to which this unit will pass
messages. This is accomplished by selecting the digit to be edited, using
◄ ►
the arrow keys. The value of the digit is changed using the
arrow keys. The user should then press ENTER.
There is a restriction on values which can be entered here; they may only
be entered in increments of 10. This is automatically taken care of; the
user may not edit the last digit of the address. This has been implemented
so that a single Master may pass messages for up to 10 devices at the
distant end. The valid range of addresses is from 10 to 9990.
But if Slave is selected, then the following sub-menu is displayed:
Address of this Slave
(◄ ►,▲ ▼,ENT)
Unit: 0241
Edit the address of this Slave unit. This is accomplished by selecting the
digit to be edited, using the
then changed using the
ENTER. The valid range of addresses is from 1 to 9999, although 'base
10' values will be automatically skipped. The Slave EDMAC address
will always end in '1'.
Remember that this is a unit which is intended to be located at the
distant-end of a link, and will therefore be under the control of a Master
at the other end. This is the equivalent of putting the unit into Remote
Control mode; no local control is possible.
6–27
◄ ► arrow keys. The value of the digit is
arrow keys. The user should then press
▲ ▼
Revision 3
MN/CDM570L.IOM
▲ ▼