Administration Group - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
SNMP Interface
19.6.1

Administration Group

This group contains system security, administration, and feature configuration
parameters.
19.6.1.1 CDM-IP Access Lists Subgroup
The Access Client List allows a user to define which remote clients can connect to a
CDM-IP570L when the Access List Enforcement is enabled. Each entry allows a user to
specify an IP address and a subnet mask to define a unique class of clients that are
allowed access to the CDM-IP570L.
19.6.1.2 Features Availability Subgroup
This subgroup tells if a feature is available or unavailable in the CDM-570/570L . The
currently supported FAST features are QoS, IGMP, 3xDES Encryption, Header
Compression and Payload Compression. These features must be purchased as additional
options.
19.6.1.3 Features Subgroup
This subgroup allows a user to enable/disable a Standard or FAST feature.
Standard features (telnet, ping response, multicast routing, and IGMP) can be enabled or
disabled by sending a 1 (enable) or 0 (disable).
FAST Features that have been purchased can be enabled or disabled by a user. Not yet
purchased FAST Features will remain disabled.
19.6.1.4 Encryption Subgroup
This subgroup controls the parameters for the Triple DES (3xDES) feature. Each
Transmit/Receive key is of 192-bit length.
Note: This subgroup will only be accessible in the MIB tree if the Encryption FAST feature has
been purchased and the license key has been entered through the modem's front panel.
Otherwise, both GETS and SETS on these OIDs will return errors.
19.6.1.5 CDM-IP SMTP
The cdmipSmtp subsection sets up the CDM570L to use a SMTP mail server to send a
problem report back to Comtech EF Data Modem Support. Along with the problem
report, the CDM570L sends the equipment serial number and configuration, which is
attached to the email message. By default, the problem report is sent to
19–10
Revision 3
MN/CDM570L.IOM