Comtech EF Data CDM-570 Installation And Operation Manual page 192

CDM-570/570L Satellite Modem with Optional IP Module
Serial Remote Control
Command
Parameter (Instruction
Type Code and
Qualifier)
OGC Outdoor OGC=
Unit Global
Configuration
Note: The following codes are used in the 'Response to Command' column:
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
~ Time out of an EDMAC pass-through message
+ Warning. Command accepted, but other parameters were changed in addition
Arguments
for Command
or Response
to Query
50 Bytes
Command or Query. CDM-570L Only
ODU Global Configuration of CDM-570L in the form:
aabcdexxxxhhhhiiiijjjjjkxxxxxxlmnnnooopppppqxxxxxx, where:
aa = BUC Address
b = BUC FSK comms enable
c = BUC Power Control
d = BUC 10MHz Frequency Reference enable
e = BUC Tx Output Enable
xxxx = expansion bytes
hhhh = BUC Low Alarm Limit
iiii = BUC High Alarm Limit
jjjjjk = BUC LO frequency, mix sign
xxxxxx = expansion bytes
l = LNB Power Control
m = LNB 10MHz Frequency Reference enable
nnn = LNB Low Alarm Limit
ooo = LNB High Alarm Limit
pppppq = LNB LO Frequency, mix sign
xxxxxx = expansion bytes
Any unavailable parameters will be filled with
xxx.
Description of Arguments
same as BAD
same as BCE
same as BPC
same as BFR
same as BOE
same as BCL
same as BCH
same as BLO
same as LPC
same as LFR
same as LCL
same as LCH
same as LLO
13–30
MN/CDM570L.IOM
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
OGC= OGC? OGC=aabcdfxxxhhhhiiii
OGC? jjjjjkxxxxxxlmnnnooopp
OGC* pppqxxxxxx
OGC# (see description of
arguments)
Where n=0 to 9
OGC?n
returns the OGC
portion of 1 of 10 stored
configurations
(see description of
arguments)
Revision 3