Config) Remcont (Remote Control); Config, Remote) Serial - Comtech EF Data CDM-570 Installation And Operation Manual

CDM-570/570L Satellite Modem with Optional IP Module
Front Panel Operation
6.5

(CONFIG) REMCONT (Remote control)

Select Local, Serial or Ethernet using the
Remote Control: Local
Serial Ethernet(◄ ►,ENT)
If Local is selected then remote control will be disabled. Remote monitoring is still
possible.
6.5.1

(CONFIG, REMOTE) SERIAL

If Serial is selected and if the unit has not been defined as an EDMAC SLAVE then:
then the following sub-menus will be displayed:
Serial Config: Interface
Baudrate
(◄ ►,ENTER)
(CONFIG, REMOTE, SERIAL, INTERFACE)
If Interface is selected:
M&C Bus Interface: RS232
RS485-2W RS485-4W
Select RS232, RS485 (2-wire), or RS485 (4-wire), using the
then press ENTER. At this point the user will be further prompted to enter the
bus address.
If RS232 is selected, the following menu is displayed:
In RS232 Mode the Bus
Address is fixed at 0000
(CONFIG, REM, SERIAL, INTFC, ADDR) RS485 BUS
ADDRESS
However, if either RS485 mode is selected, the user will be further prompted:
RS485 Bus Address: 0245
(◄ ►,▲ ▼,ENTER)
Edit the RS485 bus address of this unit. This is accomplished by selecting the
digit to be edited, using the
◄ ► arrow keys, then press ENTER.
(◄ ►)
◄ ► arrow keys. The value of the digit is then
6–7
Revision 3
MN/CDM570L.IOM
◄ ► arrow keys,