Electronic Gear Setting Area; Clutch Setting Area - Panasonic AFP7MC16EC User Manual

15.8.3 Electronic Gear Setting Area

Unit
Axis no. memory
no. (Hex)
UM 63F50
1
-UM 63F51
UM 63F52
1
-UM 63F53
1 UM 63F54
UM 63F55
1
-UM 63F5F
(Note): The above table shows the unit memory numbers of axis number 1. For details of the whole configuration,
refer to "15.8.1 Configuration of Synchronous Control Setting Area".

15.8.4 Clutch Setting Area

Unit
Axis no. memory
no. (Hex)
1 UM 63F60
1 UM 63F61
UM 63F62
1
-UM 63F67
1 UM 63F68
1 UM 63F69
UM 63F6A
1
-UM 63F6F
(Note): The above table shows the unit memory numbers of axis number 1. For details of the whole configuration,
refer to "15.8.1 Configuration of Synchronous Control Setting Area".
15.8 Unit Memories (Synchronous Control Setting Area)
Name Default Description
Set the numerator and denominator for the gear
Gear ratio
ratio of electronic gear separately.
numerator of U1
Range: U1 to U2147483647
each axis
Electronic gear ratio is determined by the following
formula.
Gear ratio
Output speed of electronic gear = Operating speed
denominator U1
of master axis x (Gear ratio numerator/Gear ratio
of each axis
denominator)
Set the time required to change the current gear
Gear ratio
ratio to a new gear ratio when the new gear ratio is
change time U1
set for the electronic gear in operation.
of each axis
1 to 10000 [ms]
Reserved
- -
for system
Name Default Description
Clutch ON
H0 H0: I/O clutch ON request
trigger type
Set the valid condition of trigger signals.
Clutch ON
H0: Level
edge H0
H1: Leading edge
selection
H2: Trailing edge
Reserved
- -
for system
Clutch OFF
H0 H0: I/O clutch OFF request
trigger type
Set the valid condition of trigger signals. This item is
unavailable when the clutch ON edge selection is
Clutch OFF
set to "H0: Level".
edge H0
H0: Disabled
selection
H1: Leading edge
H2: Trailing edge
Reserved
- -
for system
●: Available, -: Not available
R W
 
 
 
-
●: Available, -: Not available
R W
 
 
-
 
 
-
15-57
-
-
-