Table of Contents
Advertisement
Automatic Operation (Synchronous Control)
Confirmation of cam table
Confirm the set cam table (cam curve). In the synchronous control, slave axes operate
following the cam curve. Therefore, a motor may not be able to follow the output if the change
in the cam curve is rapid. For the change in the cam curve, not only the information on
displacement but also the information such as acceleration information is important. In the
cam table setting screen, the following information except displacement can be displayed.
Display item
Description
Displacement
This is set in the cam table.
The operation speed of the cam table with a set displacement amount is displayed.
Speed
Also , the display is displayed by relative values.
Accelerations at each phase are displayed.
Acceleration
Care is necessary in the area where acceleration largely changes as a rapid change in the
speed occurs.
It is obtained by differentiating an accleration by a time. It indicates a rate of change of
Jerk
acceleration.
Each display item can be set by checking the following check boxes in the cam table setting
screen. Refer to each display items, and change the cam table settings.
9-26
Advertisement
Table of Contents
