Panasonic AFP7MC16EC User Manual page 207

Name Time chart
Deceleration
stop
(Note 1)
Pause
(Note 1)
(Note 1): The deceleration stop and pause operations are switched by the "MC common setting" parameter.
 Allocation of I/O Numbers
Signal name
System stop
(Note 1): The I/O numbers in the above table show relative addresses based on the base word number. The I/O
numbers actually used vary according to the slot number where the unit is installed and the starting word
number.
 Allocation of unit memories
Signal name
Emergency stop
Deceleration stop
(Note 1): Flags or request signals for 16 axes are allocated to each unit memory (1 word) in the above table. When
the value of each bit is 1, it turns on. When the value of each bit is 0, it turns off.
bit no. 15
Axis no.
16
● ● ● ● ● ●
32
● ● ● ● ● ●
48
● ● ● ● ● ●
64
● ● ● ● ● ●
Deceleration time
E
Deceleration time
Stop is cancelled.
Axes Axes
1-16 17-32
UM001B0 UM001B1
UM001B6 UM001B7
8 7
9 8
● ● ● ● ● ●
25 24
● ● ● ● ● ●
41 40
● ● ● ● ● ●
57 56
● ● ● ● ● ●
Occurrence condition and operation
 When a deceleration stop request
(corresponding bit allocated to UM001B6 to
UM001BB) turns ON, an active operation will
stop and the operation of corresponding
axes will stop.
 Performs a deceleration stop in the
deceleration time specified for the active
positioning operation.
 When a deceleration stop request
(corresponding bit allocated to UM001B6 to
UM001BB) turns ON, an active operation will
stop and the operation of corresponding
axes will stop.
 Performs a deceleration stop in the
deceleration time specified for the active
positioning operation.
 Once a deceleration stop signal turns
OFF, the deceleration stop will be canceled
and the stopped control will restart.
I/O number
Real axis
Axes Axes
33-48 49-64
UM001B2 UM001B3
UM001B8 UM001B9
0
1
17
33
49
12.1 Type of Stop Functions
Y0
Virtual axis
Axes
1-16 17-32
UM001B4 UM001B5
UM001BA UM001BB
Axes
12-3