Table of Contents
Advertisement
Data Transfer to MC Unit and Test Operation
KEY POINTS
•
Even in the tool operation, the unit operates in accordance with the data of
the positioning table downloaded to FP7 MC Unit. The operations after the
starting table number vary depending on operation patterns.
•
If a recoverable error occurs in FP7 MC Unit, click the [Clear errors] button
to clear the error.
•
If a warning occurs in FP7 MC Unit, click [Clear warning] to clear the
warning.
The positioning operation of an interpolation group starts and stops the
•
axis with the smallest number in the group. In the case of the tool operation
function, the "Operate" buttons other than that for the smallest axis number
cannot be pressed
•
This dialog box cannot be closed during the operation.
•
When conditions are changed during the tool operation, the operation
continues by updating the unit memories temporarily, however, the
changes are not reflected in the configuration data written in the FROM
within FP7 MC Unit. Therefore, when the power is turned on again, the unit
is booted based on the cofniguration data written in the FROM within FP7
MC Unit.
6-22
Advertisement
Table of Contents
