Host Initialization - ST STM32F413 Reference Manual

USB on-the-go full-speed (OTG_FS)
33.16.2

Host initialization

To initialize the core as host, the application must perform the following steps:
1. Program the HPRTINT in the OTG_GINTMSK register to unmask
2. Program the OTG_HCFG register to select full-speed host
3. Program the PPWR bit in OTG_HPRT to 1. This drives V
4. Wait for the PCDET interrupt in OTG_HPRT0. This indicates that a device is
connecting to the port.
5. Program the PRST bit in OTG_HPRT to 1. This starts the reset process.
6. Wait at least 10 ms for the reset process to complete.
7. Program the PRST bit in OTG_HPRT to 0.
8. Wait for the PENCHNG interrupt in OTG_HPRT.
9. Read the PSPD bit in OTG_HPRT to get the enumerated speed.
10. Program the HFIR register with a value corresponding to the selected PHY clock 1
11. Program the FSLSPCS field in the OTG_HCFG register following the speed of the
device detected in step 9. If FSLSPCS has been changed a port reset must be
performed.
12. Program the OTG_GRXFSIZ register to select the size of the receive FIFO.
13. Program the OTG_HNPTXFSIZ register to select the size and the start address of the
Non-periodic transmit FIFO for non-periodic transactions.
14. Program the OTG_HPTXFSIZ register to select the size and start address of the
periodic transmit FIFO for periodic transactions.
To communicate with devices, the system software must initialize and enable at least one
channel.
33.16.3 Device initialization
The application must perform the following steps to initialize the core as a device on power-
up or after a mode change from host to device.
1. Program the following fields in the OTG_DCFG register:
–
–
2. Program the OTG_GINTMSK register to unmask the following interrupts:
–
–
–
–
–
3. Wait for the USBRST interrupt in OTG_GINTSTS. It indicates that a reset has been
detected on the USB that lasts for about 10 ms on receiving this interrupt.
Wait for the ENUMDNE interrupt in OTG_GINTSTS. This interrupt indicates the end of reset
on the USB. On receiving this interrupt, the application must read the OTG_DSTS register
to determine the enumeration speed and perform the steps listed in
enumeration completion on page
1196/1284
Device speed
Non-zero-length status OUT handshake
USB reset
Enumeration done
Early suspend
USB suspend
SOF
DocID029473 Rev 3
1218.
RM0430
on the USB.
BUS
Endpoint initialization on