Removing A Small-Form-Factor Expansion Card; Installing A Small-Form-Factor Expansion Card - IBM BladeCenter HS20 7981 Problem Determination And Service Manual

Removing a small-form-factor expansion card

To remove a small-form-factor expansion card, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Gently pivot the wide end of the card out of the expansion card connectors;

Installing a small-form-factor expansion card

To install a small-form-factor expansion card, complete the following steps:
66
BladeCenter HS20 Type 7981: Problem Determination and Service Guide
Expansion
card
"Installation guidelines" on page 55.
the blade server from a BladeCenter unit" on page 57).
page 59 for instructions).
then, slide the notched end of the card out of the raised hook on the tray and lift
the card out of the blade server.
Expansion
card