Table of Contents
Advertisement
Installing the management card
Use this procedure to install the management card into the currently installed
system board. If you are also installing a new system board, you must complete
this procedure before installing the new system board.
To install the management card, complete the following steps.
Figure 17. Installing the management card
1. Read the documentation that comes with the management card, if you ordered
2. Locate the connector on the currently installed system board into which the
3. Touch the static-protective package that contains the management card to any
4. Verify that both of the connector retaining clips are in the fully open position.
5. Turn the management card so that the management card aligns correctly with
6. Insert the management card by pressing the management card along the guides
252
JS22 Type 7998: Problem Determination and Service Guide
a replacement card.
management card will be installed. See "System-board connectors" on page 9
for the location.
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the management card
from its package.
the connector on the system board.
Attention: To avoid breaking the retaining clips or damaging the management
card connectors, open and close the clips gently.
into the connector. Make sure that the retaining clips snap into the closed
position.
Important: If there is a gap between the management card and the retaining
clips, the management card has not been correctly installed. In this case, open
the retaining clips and remove the management card. Then reinsert the
management card.
Management
card
Retaining clip
Advertisement
Table of Contents
