Table of Contents
Advertisement
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Removing the blade server cover" on page
5. Locate the CFFh expansion card. The CFFh expansion card is installed into the
6. Open the expansion-card standoff.
7. Lift the release lever to disengage the CFFh expansion card from the expansion
8. Use your fingers to hold the edge of the CFFh expansion card where it
Installing a horizontal-compact-form-factor expansion card
Use these instructions to install a compact-form-factor expansion card in the blade
server.
The blade server supports a horizontal-combination-form-factor (CFFh) expansion
card. The following illustration shows how to install a CFFh expansion card.
Attention: If the expansion card is not running at the speed supported by the
card, you can change the maximum speed of the PCIe bus in the Setup Utility by
selecting System Settings and Devices and I/O Ports.
To install a CFFh expansion card, complete the following steps:
38
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide
the blade server from the BladeCenter unit" on page 19 for instructions).
20 for instructions).
blade expansion connector (see "Blade server connectors" on page 15).
connector on the system board.
connects to the blade expansion connector; then, lift up on the card.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 17.
2. If the blade server is installed in a BladeCenter unit, remove it (see
"Removing the blade server from the BladeCenter unit" on page 19 for
instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4. Remove the blade server cover (see "Removing the blade server cover" on
page 20).
5. If an optional expansion unit is installed, remove the expansion unit (see
"Removing an optional expansion unit" on page 23).
Advertisement
Table of Contents
