Table of Contents
Advertisement
Installation
2.2
Installation
The modem arrives fully assembled from the factory. After unpacking the modem, install
the modem as follows:
1. If required, install the mounting bracket in equipment rack (Figure 2-1). Install
2. Loosen the screw with flat washer located on the left side of modem chassis.
3. Connect the cables to the proper locations on the rear panel. Refer to Section 2.3
4. Connect the primary power cable to the power source. Before turning on the
5. If problems exist with the installation, refer to
2–2
and tighten the bracket bolts.
Mount the modem chassis into the equipment rack and slide the screw with flat
washer through the slot of the mounting bracket. Tighten the screw sufficiently
to allow the modem chassis to slide in the bracket.
for connector pinouts, placement, and function.
power switch, become familiar with the front panel operation in
information.
SDM-300A Satellite Modem
Chapter
Chapter 5
for troubleshooting
3.
Rev. 4
Advertisement
Table of Contents
