Table of Contents
Advertisement
SDM-300A Satellite Modem
RX CHAN # 1 MODE
RX CHAN # 1 DR
RX CHAN # 2 MODE
RX CHAN # 3 MODE
RX CHAN # 3 DR
RX CHAN # 3 PHASE
RX CHAN # 4 MODE
RX CHAN # 4 DR
RX # 4 PHASE
Rev. 4
Programs the TX Channel # 1 mode, D&I Enabled, T1/E1 Enabled, or
Disabled.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX Channel # 1 Drive: 1544 kbit/s or 2048 kbit/s for Bypass.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX Channel # 2 mode: ADPCM Enabled or Disabled.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the RX Channel # 3 mode, ASYNC EIA-232, SYNC EIA-232,
ASYNC EIA-422, SYNC EIA-422, AUPC, or Disabled.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX Channel # 3 Drive: SYNC EIA-422: 0.6 to 4000 kbit/s.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX # 3Phase:Normal or Inverted.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX Channel # 4 mode: ASYNC EIA_232, SYNC EIA-232,
ASYNC 485, AUPC, or Disabled.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX Channel # 4 Drive., 0.6 to 64 kbit/s.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Programs the TX # 4 Phase: Normal or Inverted.
Press[←] or [→] to move the flashing cursor, and [↑] or [↓] to increment
or decrement the selected kbit/s. Press [ENTER] to execute the change.
Operation
3–33
Advertisement
Table of Contents
