Comtech EF Data SDM-300A Installation And Operation Manual page 285

Remote Control Operation
Interface Command:
Coding Response:
Format
Transmit Status:
Response:
Interface Command:
Coding Response:
Format
Receive Status:
Response:
Transmit Command:
Data Fault Response:
Status:
Response:
Receive Command:
Data Fault Response:
Status:
Response:
Interface Command:
Service Response:
Channel
Level Status:
Response:
IDR Command:
Backward Response:
Alarm
Enable Status:
Response:
Drop Data Command:
Format Response:
Status:
Response:
Insert Data Command:
Format Response:
Status:
Response:
Insert E1 Command:
CRC Response:
Enable
Status:
Response:
B–10
<add/ICFT_xxxx'cr'
>add/ICFT_xxxx'cr''lf']
<add/ICFT_'cr'
>add/ICFT_xxxx'cr''lf']
<add/ICFR_xxxx'cr'
>add/ICFR_xxxx'cr''lf']
<add/ICFR_'cr'
>add/ICFR_xxxx'cr''lf']
<add/TDF_xxxx'cr'
>add/TDF_xxxx'cr''lf']
<add/TDF_'cr'
>add/TDF_xxxx'cr''lf']
<add/RDF_xxxx'cr'
>add/RDF_xxxx'cr''lf']
<add/RDF_'cr'
>add/RDF_xxxx'cr''lf']
<add/ISCL_xxx_snn'cr'
>add/ISCL_xxx_snn'cr''lf']
<add/ISCL_xxx'cr'
>add/ISCL_xxx_snn'cr''lf']
<add/BW_xxx_nnn'cr'
>add/BW_xxx_nnn'cr''lf']
<add/BW_xxx_'cr'
>add/BW_xxx_nnn'cr''lf']
<add/DDF_xxxxxx'cr'
>add/DDF_xxxxxx'cr''lf']
<add/DDF_'cr'
>add/DDF_xxxxxx'cr''lf']
<add/IDF_xxxxxx'cr'
>add/IDF_xxxxxx'cr''lf']
<add/IDF_'cr'
>add/IDF_xxxxxx'cr''lf']
<add/ICRC_xxx'cr'
>add/ICRC_xxx'cr''lf']
<add/ICRC_'cr'
>add/ICRC_xxx'cr''lf']
SDM-300A Satellite Modem
Where: xxxx = AMI, HDB3, or B8ZS.
Where: xxxx = AMI, HDB3, or B8ZS.
Where: xxxx = NONE, DATA, or AIS.
Where: xxxx = NONE, DATA, or AIS.
Where:
xxx = TX1, TX2, RX1, or RX2 (service channel
designator).
nnn = -20 to +10 in steps of 1 (service channel level in
dBm).
Where:
xxx = TX1, TX2, TX3, TX4, RX1, RX2, RX3, or RX4
(backward alarm designator).
nnn = ON or OFF.
Where: xxxxxx = T1, T1ESF, T1IBS, E1CCS, E1CAS,
E1IBS, E131TS, T1S, or T1ESFS.
Where: xxxxxx = T1, T1ESF, T1IBS, E1CCS, E1CAS,
E1IBS, E131TS, T1S, or T1ESFS.
Where: xxx = ON or OFF.
Rev. 4