Comtech EF Data SDM-300A Installation And Operation Manual page 325

Remote Control Operation
Boot M&C Command:
Firmware Response:
Information
Modem Command:
Options/ Response:
Misc.
Information
Card #1 Command:
Type Response:
Information
Card #2 Command:
Type Response:
Information
Card #3 Command:
Type Response:
Information
B–50
<add/BFI_'cr'
>add/BFI_'cr'
VER_xxx.yyy.zzz'cr'
FW/nnnnnn-ddr'cr'
mm/dd/yy'cr''lf']
<add/MOI_'cr'
>add/MOI_'cr'
s,HGH_PWR'cr'
s,HGH_STAB'cr'
s,ASLT'cr'
s,VIT'cr'
s,SEQ'cr'
s,SR'cr'
s,LRV'cr'
s,FRV'cr'
s,CARD_1_PCB'cr'
s,CARD_2_PCB'cr'
s,CARD_3_PCB'cr'
s,8PSK_2/3'cr'
s,TX_ONLY'cr'
s,RX_ONLY'cr'
s,OQPSK'cr''If']
<add/C1TI_'cr'
>add/C1TI_'cr'
ttttt'cr''lf']
<add/C2TI_'cr'
>add/C2TI_'cr'
tttt'cr''lf']
<add/C3TI_'cr'
>add/C3TI_'cr'
tttt'cr''lf']
Where:
xxx.yyy.zzz = Software version number (0.0.0 to
999.999.999).
nnnnnn = Firmware number (0 to 999999).
dd = Firmware dash number (0 to 99).
r = Firmware revision (-, or A to Z).
(0 or +) High Power
(0 or +) High Stability
(- or +) Asymmetrical Loop Timing
(- or +) Viterbi Encoder/Decoder
(- or +) Sequential Encoder/Decoder
(- or +) Single Code/Data Rate
(- or +) Low Rate Variable
(- or +) Full Rate Variable
(x or +) Card #1 Installed
(x or +) Card #2 Installed
(x or +) Card #3 Installed
(- or +) 8PSK 2/3 Code Rate
(0 or +) TX Only Operation
(0 or +) RX Only Operation
(O or +) OQPSK 1/2, 3/4, 7/8
Notes:
1. s = 0 (Not Installed, Not Upgradable).
2. - (Not Installed, FAST Upgradable).
3. + (Installed).
4. X (Not Installed, Field Upgradable).
Where: ttttt = type (OH_01, MUX_01, FMUX_01, or
NOT_INSTALLED).
Where: tttt = type (RS_02, RS_03, or NOT_INSTALLED).
Where: tttt = type (RS_02, RS_03, or NOT_INSTALLED).
SDM-300A Satellite Modem
Rev. 4