Table of Contents
Advertisement
SDM-300A Satellite Modem
2.3.3.1.1
Data I/O Connector (J8) Removal
1. (For Ribbon-Configured Connector PL/6031.) Remove Data I/O connector (J8)
2. (For Part No. PL/5509-1.) Remove 50-pin Data I/O connector (J8) as follows:
Rev. 4
(Figure 2-7) as follows:
a. Remove four screws securing the rear panel to the chassis.
b. Pull out rear panel to gain access to disconnect connector (J8).
c. Disconnect connector (J8) from the PCB.
d. Remove the four screws securing connector (J8) to the rear panel.
e. Remove the connector (J8).
a. Remove the four screws securing the connector (J8) to the rear panel.
b. Establish a grip on connector (J8) and pull backwards until separation of the
connectors is obtained.
c. Remove connector (J8).
Installation
2–15
Advertisement
Table of Contents
Need help?
Do you have a question about the SDM-300A and is the answer not in the manual?
Questions and answers