SDM-300A Satellite Modem
SDM-6000 Emulation Operation, 3–84
SDM-6000 Emulation Parameter Settings, 3–84
Seconds to Bits, 3–98
Self-Monitoring Local Modem AUPC Control, A–22
Send Clock Timing Source, C-32
Sequential Decoder, 1–5, A–41
Sequential Decoder Block Diagram, A–41
Software Configuration, 3–76
Specification Summary, A–77
Specifications, 4–6, A–8, A–44, A–49, A–61, A–66, A–77,
A–79, A–81, C-1
Specifications Summary, A–77
Spurious Emissions, C-25
Start Character, B–2
Status Commands/Responses, B–21
Stored Faults, 3–2, 3–5, 3–44, 3–45, 3–62, B–14, B–30,
B–35, B–36
Stored Faults /Alarms, 3–2, 3–5, 3–44, 3–45
Stored Faults /Alarms Menu, 3–44
Switch Faults, C-34
System Checkout, 5–1
System Faults/Alarms, 5–8
System-Related Specifications, C-45
System Specification, A–77, A–79, A–80
T1 Framing Formats, A–17
Terrestrial Data Interfaces, A–23
Terrestrial Interface Types, C-34
Test Modes, C-45
Theory of Modulation Types, 4–7
Theory of Operation, 4–2, 4–6, 4–10, A–1, A–12, A–23,
A–42, A–44, A–62
Total Buffer Length, 3–98
Transmit Clock Phase Adjustment, C-32
Transmit Clock Source, C-32
Transmit Clock Switching Due to Failure of Selected
Clock, C-32
Transmit Data Phase Adjustment, C-32
Transmit IF Output Switch, C-25
Transmit IF Power, C-25
Transmit IF Test Modes, C-26
Transmit Frequency (IF), C-24
Rev. 4
T
Transmit Frequency Change Time, C-24
Transmit Interface Faults, 3–40, 5–15
Transmit Section of the Asymmetrical Loop Timing Block
Diagram, A–56
Transmitted MUX, A–12
Typical Eye Constellations, 5–7
Typical Output Spectrum (with Noise), 5–5
Typical Output Spectrum (without Noise), 5–5
Typical Spectral Occupancy, 1–12
UB-300 Universal Breakout Panel, 1–10, 2–4
UB-54 Breakout Panel, 1–10, 2–4
Unavailable Seconds Fault, 3–45
Universal, C-34
Unpacking, 2–1, A–1, A–67
Utility Demodulator, 3–53, 3–54, 3–80, 3–82, 3–83, 3–84
Utility Demodulator Menu, 3–53
Utility Factory Setup, 3–49, 3–71
Utility Factory Setup Menu, 3–71
Utility Interface, 3–19, 3–56, 3–57, 3–58, 3–75, 3–77,
3–82, 3–83, 3–84, A–23, A–26, A–27, A–30, A–31,
A–32, A–33, A–34, A–35, A–36, A–38, A–46, A–67
Utility Interface Menu, 3–56, 3–57, A–30, A–31, A–32,
A–33, A–34, A–35, A–36, A–38
Utility Modem Type Functions, 3–68
Utility Modem Type Menu, 3–66, 3–67
Utility Modulator, 3–50, 3–51, 3–80, 3–82, 3–83, 3–84
Utility Modulator Menu, 3–51
Utility System, 3–60, 3–61, 3–62, 3–75, 4–4, A–30, A–31,
A–32, A–33, A–34, A–35, A–36, A–38
Utility System Menu, 3–60, 3–61, A–30, A–31, A–32,
A–33, A–34, A–35, A–36, A–38
V.35 Specification V.10 V.11 Specification, Circuit
Supported, C-35
Valid ASYNC Baud Rates, A–27
Variable Data Rates, A–1, A–59
Viterbi Decoder, 4–12, A–43
Viterbi Decoder Block Diagram, A–43
Viterbi Specification, A–44
Index
U
V
i–5
Need help?
Do you have a question about the SDM-300A and is the answer not in the manual?