X Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – 802.1x
H3C S9500 Series Routing Switches
Perform
handshake-period timer:
Enable the handshake-period timer
Disable the handshake-period timer
By default, the handshake-period timer is enabled.
Note:
The undo dot1x handshake enable command takes effect immediately for all users,
while the dot1x handshake enable command takes effect only for users who pass
authentication after you configure the command. You are recommended to configure
the commands before user authentication.
1.3 Displaying and Maintaining 802.1x
Display the configuration,
running and statistics
information of 802.1x
Reset the 802.1x
statistics information
Enable the
error/event/packet/all
debugging of 802.1x
Disable the
error/event/packet/all
debugging of 802.1x.

1.4 802.1x Configuration Example

I. Network requirements
As shown in
of the Switch.
the following operations
To do...
To do...
display dot1x [ sessions |
statistics | enabled-interface |
guest vlan ] [ interface interface-list
| sessions | statistics]
reset dot1x statistics [ interface
interface-list ]
debugging dot1x { error | event |
packet | all }
undo debugging dot1x { error |
event | packet | all }
Figure 1-2, the workstation of a user is connected to the port Ethernet 2/1/1
in system view
Use the command...
dot1x handshake enable
undo dot1x handshake enable
Use the command...
1-12
Chapter 1 802.1x Configuration
to enable/disable
Remarks
Available in any
view
Available in user
view
Available in user
view
Available in user
view
the