Resetting The System Of An Oap Module - H3C S9500 Series Operation Manual

Routing switches

Hide thumbs Also See for S9500 Series:

Table of Contents

Operation Manual – OAP Module

H3C S9500 Series Routing Switches

Before the above configuration, you are recommended to configure the same IP

address at the OAP module side; otherwise, the NMS cannot access the OAP

module by using the configured management IP address.

For operations on the OAP module side, refer to the corresponding document of

1.4 Resetting the System of an OAP Module

If the operating system works abnormally or is under other anomalies, you can reset the

system of an OAP module with the following command, which is equal to resetting the

OAP module by pressing the reset button on the OAP module.

An OAP module has its independent CPU; therefore, the device can still recognize and

control the OAP module after you reset the OAP system.

Follow the step to reset the system of an OAP module:

Reset the system of an

Reset of the OAP module may cause data loss and service interruption. Therefore,

before resetting the OAP module, you need to save the configurations of the OAP

module operating system and shut down the OAP module operating system to avoid

service interruption and hardware data loss.

For operations on the OAP module side, refer to the corresponding document of

oap reboot slot

Chapter 1 OAP Module Configuration

Use the command...

Available in user view

Table of Contents