H3C S9500 Series Operation Manual page 1415

Operation Manual – Cluster Management
H3C S9500 Series Routing Switches
[H3C] interface ethernet 1/1/1
[H3C-Ethernet1/1/1] hgmpport enable
[H3C-Ethernet1/1/1] interface ethernet 1/1/2
[H3C-Ethernet1/1/2] hgmpport enable
# Use the display command to display the information about the switches registered
with Switch A, through which you can obtain position parameters of each switch.
<H3C> display lanswitch all
Lanswitch list.........
------------------
No. 1
------------------
------------------
No. 2
------------------
# Set an alias for the switch 1/1/1-/ on the management device.
[H3C-hgmp] set lswname 1/1/1-/ switch1
# Set duplex state to auto for port 1 of Switch B on the management device.
[H3C-hgmp] lanswitch 1/1/1-/
[H3C-lanswitch1/1/1-/] duplex port 1 auto
# Set duplex state to auto for port 1 of Switch C on the management device.
[H3C-hgmp] lanswitch 1/1/2-/1/
[H3C-lanswitch1/1/2-/1/] duplex port 1 auto
Position : LANSWITCH[1/1/1-/1/]
PortMode : STAR_MODE
Lanswitch Name : lan1
Model : H3C S2008
Device ID : Vc.3.2
MacAddr : 00e0-fc2d-1f9c
Status : NORMAL
Position : LANSWITCH[1/1/2-/1/]
PortMode : STAR_MODE
Lanswitch Name : lan2
Model : H3C S2026B
Device ID : V10.30.1
MacAddr : 00e0-fc26-dfb7
Status : NORMAL
Chapter 1 HGMP V1 Configuration
1-14