H3C S9500 Series Operation Manual page 1436

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Module name
POS_SNMP
PPP
PSSINIT
RDS
RM
RMON
RPR
RSA
RTPRO
SHELL
SNMP
SOCKET
SSH
SYSM
SYSMIB
TAC
TELNET
USERLOG
VFS
VLAN
VOS
VRRP
VTY
Notice: There is a slash ('/') between module name and severity.
6) Severity
System information is classified into three types: log information, debugging
information, and trap information. Depending on the severity & emergency degree,
each kind of information can be further divided into eight levels. Information filtering by
severity works this way: information with the severity value greater than the configured
threshold will not be output during the filtering. The smaller the severity value, the
higher the severity. "emergencies" indicates a severity of 1, and "debugging" indicates a
severity of 8. If the severity threshold is set to "debugging", all information can be output.
The table below describes the eight severity level.
Description
POS simple network management protocol module
Point to point protocol module
PSSINIT module
RADIUS module
Routing management module
Remote monitor module
Resilient packet ring module
RSA (Revest, Shamir and Adleman) encryption module
Routing protocol module
User interface module
Simple network management protocol module
Socket module
Secure shell module
System manage veneer module
System MIB module
Terminal access controller module
Telnet module
User calling logging module
Virtual file system module
Virtual local area network module
Virtual operate system module
VRRP (virtual router redundancy protocol) module
VTY (virtual type terminal) module
1-4
Chapter 1 Information Center