H3C S9500 Series Operation Manual page 877

Operation Manual – MPLS VPLS
H3C S9500 Series Routing Switches
As an access device on the user side, UPE provides access to NPE1 and NPE2
by primary/backup PW. Users under the UPE can communicate with other users
in the VPLS network through NPE1 or NPE2.
II. Network diagram
Figure 1-6 Network diagram for H-VPLS configuration (via MPLS)
III. Configuration procedure
Note:
In the example, slot 2 holds the public network interface card, slot 5 holds the MPLS
card, slot 3 holds the VPLS service card.
If the access card on the public network side is an MPLS card, you simply need to
redirect the VPLS packets to the VPLS service card for redirection, without using the
join-vlan parameter.
If the access card on the public network side is a non-MPLS card, you need to
redirect the VPLS packets to the VPLS service card for redirection and use the
join-vlan parameter to add the ports to the VLANs.
1) Configure NPE1.
# Configure MPLS globally.
<H3C> system view
[NH3C] sysname NPE1
[NPE1] mpls lsr-id 1.1.1.1
[NPE1] mpls
[NPE1-mpls] quit
[NPE1] mpls ldp
1-26
Chapter 1 VPLS Configuration