H3C S9500 Series Operation Manual page 1440

Operation Manual – Information Center
H3C S9500 Series Routing Switches
4) Sending information to the log buffer
Table 1-7 Send information to the log buffer
Device
Switch
5) Sending information to the trap buffer
Table 1-8 Send information to the trap buffer
Device
Switch
6) Sending information to SNMP
Configuration
Enable information
center
Set the information
output direction to
the logbuffer
Set information
source
Configuration Default value
By default,
Enable
information
information
center is
center
enabled
Set the
information
—
output direction
to the trapbuffer
Set information
—
source
1-8
Chapter 1 Information Center
Default value
By default,
Other configurations are
information valid only if the
center is information center is
enabled enabled
You can configure the
— size of the log buffer at the
same time.
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
—
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Configuration description
Other configurations are valid
only if the information center is
enabled
You can configure the size of
the trap buffer at the same time
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module before
defining output debugging
information
Configuration
description