H3C S9500 Series Operation Manual page 1408

Routing switches
Hide thumbs Also See for S9500 Series:
Table of Contents

Advertisement

Operation Manual – Cluster Management
H3C S9500 Series Routing Switches
In addition, you can set the state of a managed switch to be active or inactive on the
management device.
Perform the following configuration to set the state and alias of a managed switch:
Set the state of a specified
switch
Configure an alias for an
switch
Remove a configured
alias
Save the configuration information to the flash memory of the management device
using the backup lswconfig command.
1.2.5 Configuring a Specific Low-End Switch through the Management
Device
S2008B/S2016B/S2026B and S2403F switches are all low-end switches. After
enabling HGMP Server on the management device and HGMP Client on these low-end
switches, you can manage the connected low-end switches through the management
device.
Using HGMP, you can configure any connected low-end switch by configuring the
management device. You can perform the following configuration on the management
device to configure the connected low-end switches: port rate configuration, port
aggregation configuration, VLAN configuration, address table configuration, VLAN
management configuration, and so on.
I. Specifying default configuration settings
These operations are applicable to S2008B/S2016B/S2026B/S3026 switches.
You can specify the configuration of a switch, such as port rate, flow control, duplex
settings and tag status of the port, to be the default configuration settings and apply it to
all switches that are of the same model, through which you can have other switches
automatically configured using the auto config command.
Perform the following configuration to specify default configuration settings:
Specify the configuration
of a switch to be the
default configuration
settings
To do...
set lanswitch
lanswitch-loc { inactive |
active }
set lswname
lanswitch-loclist name-list
undo set lswname
lanswitch-loclist
To do...
set lswconfig
lanswitch-loc asdefault
Use the command...
Use the command...
1-7
Chapter 1 HGMP V1 Configuration
Remarks
Available in HGMP view
Available in HGMP view
Available in HGMP view
Remarks
Available in HGMP view

Advertisement

Table of Contents
loading

Table of Contents